The blinking light typically indicates water heat was not detected during the cycle. You can stop the blinking and attempt to fix the problem by running a diagnostic cycle using the control panel on your dishwasher.Click to see full answer. In this manner, why is my Whirlpool dishwasher light flashing?Whirlpool Dishwasher lights flashing or blinking. The heating element heats up the water to operating temperature. If the water doesn’t reach the proper temperature after a set amount of time, a light on the control panel might start flashing. If the heating element does not have continuity, replace it.Also Know, how do you reset a Whirlpool dishwasher? To reset it, you will have to have the door open. It can not be latched. Press “Heated Dry,” “Normal,” “Heated Dry,” “Normal” within three seconds of the first pressed button. Now close the door, this should reset your dishwasher. Similarly, it is asked, why are the lights on my dishwasher flashing? Blinking “Start/Reset” light: Indicates that the dishwasher has been reset and is in the process of turning off. Other blinking lights or beeping sounds: May indicate a problem with the dishwasher caused by power surges. Try pressing the “Start/Reset” pad to reset the dishwasher and wait 2 minutes.How do I get my Whirlpool dishwasher into diagnostic mode?Here’s the instructions to get into the diagnostics mode: Entry sequence: Press any 3 keys in the sequence 1-2-3, 1-2-3, 1-2-3 with no more than 1 second between key presses. NOTE: Some models have replaced the “Clean” LED with “Completed.” The Service Diagnostics Cycle will start when the door is closed.
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6wn7Jlmah6rsWMsJ%2BiqpylvLC4jJ2grKCnlsCpsdFmo6KfmKnAbq7LoqWkoZ6cenN7